Labnet Prism R Refrigerated Microcentrifuge Manuel d'utilisateur télécharger pdf (Page 17)

personnel only. Repairs performed by unauthorized personnel may

void the warranty.

6.2. Cleaning the Centrifuge

Always keep the centrifuge housing, rotor chamber, rotor and rotor

accessories clean. All parts should be wiped down periodically with a

soft cloth. For more thorough cleaning, use a neutral cleaning agent

(pH between 6 and 8) applied with a soft cloth. Excessive amounts of

liquid should be avoided. Liquid should not come into contact with the

motor. After cleaning, ensure that all parts are dried thoroughly by

hand or in a warm air cabinet ( Maximum temperature: 50°C).

6.3. Cleaning the Rotor

The rotor should be cleaned after each use. When spinning samples

containing phenol or phenol chloroform, the rotor should be cleaned

immediately after use

6.4. Disinfection

Should a spill of infectious materials occur within the rotor or chamber,

the unit should be disinfected. This should be performed by qualified

personnel with proper protective equipment.

6.5. Replacing the Rotor

The Prism R

comes complete with a standard 24-place rotor installed.

To remove the rotor, remove the rotor securing screw from the motor

shaft by turning the screw, using the rotor wrench on two holes of the

securing screw (Please refer Figure 1). Lift the rotor directly upward in

a straight vertical motion.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Labnet Prism R Refrigerated Microcentrifuge Manuel d'utilisateur Page 17